ESPIXEL WS2811 Prop...
 
Notifications
Clear all

ESPIXEL WS2811 Prop Strobing

8 Posts
4 Users
0 Reactions
2,022 Views
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago
[#53489]

Have a prop on ESPIXELstick that is strobing at the end of the sequence, and stops responding. I'm on the latest Vixen release. Any ideas where to start?


7 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

And it works fine for the rest of the sequence? You may have an effect in the sequence that is tiny and difficult to see.


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Possibly. It will do one loop of the sequence. Then when it should go off, it starts strobing, probably once a second and never stops. All the other lights turn off then start the sequence again.


Reply
Posts: 18
(@brianamos)
Eminent Member
Joined: 6 years ago

Is this a vixen issue or a pixel stick issue, or a combination of both? The pixel stick can run a sequence (such as flashing) when it’s not receiving e1.31 data. It should have a delay but that can be reduced to 0. Also, vixen may not be broadcasting data to universes that are not in use, which may kick in the pixel stick default. Open the pixel stick settings and you can see if it’s running on its own.


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

I will do that. Would a test on the pixelstick stop it from executing a second time? It does run through the first sequence fine. I have it unplugged right now, but I'll check that in the morning.


Reply
Page 1 / 2
Share: