Pic Chip Not Found
 
Notifications
Clear all

Pic Chip Not Found

8 Posts
5 Users
0 Reactions
4,345 Views
Posts: 150
Topic starter
(@sparkey)
Estimable Member
Joined: 19 years ago

I followed the steps in the "Programming the PIC16F688" link and got the same error message (see the picture: Pic-Error-1.JPG‎ in my first post) during several of the steps.
Update.......... I just tried again but...
I noticed on the first page of your file that you had the PICkit plugged directly to the board. I was using the attachment cable that came with the unit. On a whim I ditched the cable and plugged directly to the board and it did recognize the micro chip. The programming worked, per the MPLAB message. Now I need to program the rest of the chips and see if the RenXC64 I built works.
Big thanks for your help!


Reply
RavingLunatic
Posts: 1502
(@ravinglunatic)
Noble Member
Joined: 19 years ago

Good to see it worked out.

If you want to try your cable again, it looks in the cable was not correctly oriented. Looks like the green wire goes from the arrow (Pin 1) on the PICKIT2 but doesn't go to the arrow on the programming board. Try swapping the cable around on the programming board, unless you tried it already.


Reply
Posts: 150
Topic starter
(@sparkey)
Estimable Member
Joined: 19 years ago

I was wondering about that but, as the unit is new, I figured the labels on the cable were correct (kind of like a cross over cable). On the Male end the Green wire is VPP/MCLR and on the Female end the Green wire is Aux. So I guess the label on the Female end is on the wrong side of the connector.


Reply
Page 2 / 2
Share: