Hi there. I tried to figure this programming out by watching the videos here:
http://www.doityourselfchristmas.com/wiki/index.php?title=WayneJ%27s_video_series_on_PIC_programming
and reading the Wiki but I'm getting an error that asks me to verify the PIC 16F688 is correctly installed.
I'm using a PICkit2 and a Joshua ZIF, pictures attached to show my setup. Any ideas on what I'm doing wrong?
Thanks
PS. The picture does not show it but I did install the jumpers on all of the "C" pins for the ICSP14 Adapter.
did you install the jumpers on your Ji.SYS PIC board? there are some that need to be installed to be able to comunicate with the chip. should be instructions that tell which letter should be jumpered.
You need jumpers on all 5 pins labeled BC
Joel
jrock64 wrote:You need jumpers on all 5 pins labeled BC
As is show in the Wiki. (PICkit 2 same as PICket3)
Programming the PIC16F688
Yes, all of the "C" pins have a "B" above the C for a total of 5 jumpers on the "B-C" pins. I called them the "C" pins as they are labeled as: "Group C ‐ 14 pin VPP=4, VDD=1, VSS=14, PGD=13, PGC=12; PIC16F505, PIC16F506, PIC16F526, PIC16F610, PIC16F616, PIC16F630, PIC16F636, PIC16F676, PIC16F684, PIC16F688, PIC16HV610, PIC16HV616" in the ICSP™ Adapters Instruction Manual. Thank you for the Wiki link, I did not find that one. The most obvious Wiki link is "WayneJ's video series on PIC programming". I will look at your "Programming the PIC16F688" link and post an update.
