115,200 baud rate p...
 
Notifications
Clear all

115,200 baud rate program pic question

20 Posts
9 Users
0 Reactions
14.9 K Views
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago
[#6619]

I have added a "1" in the define area to get Non-PWM for dimming LEDs. What has got me stumped is where do I incorporate the 115,200 in the define lines?

#define CLOCKRATE 18432000
#define BAUDRATE 115200 <-- Is this the only place that I type in 115,200 or is there somewhere else that I should type it in as well?

Is there anything else that needs to be done to get a Ren 24 up and running at 115,200?

Thanks go out to Phill for the firmware code 🙂 and Frank for the board layout:-).


19 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

That is the only line that you need to change...


Reply
g2ktcf
Posts: 3651
(@g2ktcf)
Famed Member
Joined: 18 years ago

Are there any specific challanges to doing this? Cabling or other?

Thanks,
Chris


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

The only challenge that I'm aware of is that some of the USB-serial converters don't seem to work with Renard at 115200. I'm not sure what the problem is, perhaps their baud rate is off by enough to cause problems.


Reply
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

Would I run into problems if I use an DB9 to RJ485 converter you can get on Ebay?


Reply
Page 1 / 4
Share: