Make PCBoards on CN...
 
Notifications
Clear all

Make PCBoards on CNC

13 Posts
6 Users
0 Reactions
8,602 Views
Posts: 2541
(@lightup)
Famed Member
Joined: 17 years ago

After milling, do you cover all the tracks with solder?
PCB material is usually 1 oz thick, unless it is copper plated to 2oz?

Well, at least at my former work place they used to copper plate the boards for a thicker layer and then tin-lead plate it after that. Now lead is out so another material may have taken its place.


Reply
jrock64
Posts: 1099
(@jrock64)
Noble Member
Joined: 19 years ago

I just used 1oz copper for those.
I had some Tin It. Two packages of powder you mix with water and place your boards in for 20 minutes to give them a shiney coating.

Did not notice any difference in solder ability.

Joel


Reply
Posts: 555
Topic starter
(@zaker)
Honorable Member
Joined: 19 years ago

Hot dang it worked! We didn't have any small v bits, but had a larger one used for engraving. Cut a board I had made in Eagle on a scrap piece of plexiglass. Looked good except some of the thinner traces were almost gone because of the size of the bit, but it worked on our mill.
Get some small bits and I'm in good to go!


Reply
Page 2 / 2
Share: