Long Thread Cable G...
 
Notifications
Clear all

Long Thread Cable Gland

9 Posts
6 Users
0 Reactions
3,017 Views
Kev7274
Posts: 2037
Topic starter
(@kev7274)
Famed Member
Joined: 13 years ago
[#48457]

Anybody know where to get some cable glands that have longer threads than the regular ones?
My wood is 3/4 and the regulars don't have enough thread on them. A long thread M32 would be nice or even smaller ones with longer threads will work.
Unless,somebody has another option?


8 Replies
DrNeutron
Posts: 2018
(@drneutron)
Noble Member
Joined: 14 years ago

When I built my small matrix, I just removed the nut and screwed the gland into the wood. It fit very snug and just put a bit of clear silicone around it to seal. This was 3 years ago.....


Reply
Kev7274
Posts: 2037
Topic starter
(@kev7274)
Famed Member
Joined: 13 years ago
DrNeutron wrote:When I built my small matrix, I just removed the nut and screwed the gland into the wood. It fit very snug and just put a bit of clear silicone around it to seal. This was 3 years ago.....

Dang good idea Phil,thanks.


Reply
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

Depending on how your project is built you could also use a forstener bit/router to thin the area where the glands go.


Reply
Kev7274
Posts: 2037
Topic starter
(@kev7274)
Famed Member
Joined: 13 years ago
StickyWicket wrote:Depending on how your project is built you could also use a forstener bit/router to thin the area where the glands go.

I did do that with another project. By the time I got it to fit correctly,the left over wood was so thin,it about cracked when trying to tighten the nut.


Reply
Posts: 215
(@reelpilot)
Reputable Member
Joined: 12 years ago
Kev7274 wrote:Dang good idea Phil,thanks.

I did the same thing except with epoxy inside the hole of wood frame. It has worked great for two seasons now and it's as solid as the day I made it.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Drill a large hole and put a piece of sheet metal there for the gland nut to attach to.

Sent from my SM-G930V using Tapatalk


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Lots of good ideas. Here is one more.

Drill the large hole (as said before), but make it so a washer can slip down into it. Put the gland through the wood, then the washer. It should tighten up just fine, without cracking the wood.


Reply
Kev7274
Posts: 2037
Topic starter
(@kev7274)
Famed Member
Joined: 13 years ago

Thanks for all the Great suggestions guys,I appreciate it.
I just drilled a hole as Dr.Neutron mentioned and screwed it in and then used epoxy. Worked great. That sucker isn't going anywhere.


Reply
Share: