Not sure what you need a picture of, but here is one of the parts mounted inside the plastic junction box I purchased.
Fpp does have a way to setup things concerning the GPIO pins, but have left it blank as the other test.py file worked. However, looking at the test.py program now it appears to do the setting up inside the file itself. I have tried tinkering with those settings with no luck yet. Basically, I do not have FPP setup for the pins yet and not sure how to do it.
I wanted a picture of your FPP config screen where you configured the GPIOs. I had not seen such a configuration before and was wondering if you had customized the FPP in some way. You might ask on the Falcon Christmas forum if there is a way to get the FPP to output to the GPIO pins as an eight bit parallel output. If it cant, then you will need to use some other controller between the FPP and the relay board.
In FPP, he would create 8 individual GPIO Channel Outputs, each set to a different start channel and GPIO number. That would allow FPP to control multiple relays on its GPIO outputs.
The problem is the active low vs active high. FPP sets the pins for output and drives them high when the channel data is non-zero. I believe there are several threads on the falcon site about trying to use these boards with FPP.
CaptainMurdoch wrote:In FPP, he would create 8 individual GPIO Channel Outputs, each set to a different start channel and GPIO number. That would allow FPP to control multiple relays on its GPIO outputs.The problem is the active low vs active high. FPP sets the pins for output and drives them high when the channel data is non-zero. I believe there are several threads on the falcon site about trying to use these boards with FPP.
Tongue in cheek wise guy response: Do the sequence with the settings reversed. Turn on the channel when you want it off and off when you want it on. Then the only issue is the level shifting and pullup resistors. You can place a zener diode between the GPIO and the relays. If you are going to go to all that trouble, then you might as well put an octal inverter on a small board and wire the relays to it.
I am going to look at adding an invert setting to the channel output to allow FPP to be active-low. I think this would be an easy change but not sure when I could slip it in.

