Using Pixel strips ...
 
Notifications
Clear all

Using Pixel strips on a real tree

12 Posts
5 Users
0 Reactions
4,368 Views
TomsLEDs
Posts: 443
Topic starter
(@tomsleds)
Honorable Member
Joined: 7 years ago
[#57111]

I have an aborvitae tree that has outgrown the Twinkly lights i use on it. Thinking of buying several pixel strips and tie them at the top and fan them out at the base. Could I still use a meagtree layout in Vixen?


11 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

It sounds like a megatree to me Tom. I don't see why it would not work. Complete control over the arborvitae!


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Pixel strips are very easily damaged due to movement. A tree, catching a gust of wind, would move them quite a bit - enough to break the copper within the strip. Read that as repair after repair after repair.

Now, if you meant "strings" with individual nodes/bulbs, then you need to make sure the stress in any movement is not being placed on the connection points at each node. We used cable to attach the pixels to, with the data and power wires between NOT taking on any stress. Worked great.


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

What algerdes said. If your branches sway in the wind at all, you're inviting the Angel of Christmas Medieval Torture upon yourself. But it could be done, so long as you're aware of the potential problem.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

First: Yes megatree will work in vixen.
Next, I use 5m 3:1 IP68 silicon sleeve pixel strings attached to a tree in my front yard. There is very little tension on them and they do move a lot. The biggest problem I have is squirrels and chipmunks chewing up the wires. They don't seem to like the silicon sleeve. I will occasionally find one of the wires chewed off and the end dragged into a nest at the base of the tree.


Reply
Page 1 / 3
Share: