Need Help with Smal...
 
Notifications
Clear all

Need Help with Smaller Mega Tree

11 Posts
7 Users
0 Reactions
5,421 Views
Posts: 110
Topic starter
(@todd1814)
Estimable Member
Joined: 11 years ago

Thank you. That's a lot nicer than the mega tree calculator I was using. I can visualize what I want a lot better than drawing it with sketchup.


Reply
Posts: 110
Topic starter
(@todd1814)
Estimable Member
Joined: 11 years ago
barlav wrote:Have you considered building the portable hole II? http://www.magicchristmasnews.org/portable%20hole%20ii.pdf

I have but I'm trying to keep costs down for my first year and I have quite a slope in the yard.


Reply
Posts: 11
(@wardawg)
Active Member
Joined: 10 years ago

I am working on almost the exact same tree. I went with the holidaycoro quick tree topper the q2 or 8.5 inch topper and the 3 inch pixel strips. It mounts onto a 1 3/8 top rail (chain link fencing rail). So far it has come out well I have a slope in my yard and was planning on pounding the rail into the ground but decided against it and made a base I will just shim the front leg. Bottom rail is is 3/4 emt bent in a 5 ft diameter and strings are 6.25 inches apart center to center. Here is a picture not completed still needs a rope in the middle of the emit to put a little tension on the strips.

IMG 5536

Reply
Posts: 110
Topic starter
(@todd1814)
Estimable Member
Joined: 11 years ago
stallionent wrote:Check out my Thread for info. Mine is 20 strands, 50 pixels up and 50 pixels down. I used a top rail of a chain link fence. No power injection.

http://doityourselfchristmas.com/forums/showthread.php?42600-Project-180-x-10-ft-Mega-Tree&highlight=project+mega+tree

Were your pigtails long enough to reach the light strings from the controller or did you have to add wire in between the two?


Reply
stallionent
Posts: 1460
(@stallionent)
Noble Member
Joined: 13 years ago

I bought pixels from Holidaycoro with pigtails already on them http://www.holidaycoro.com/12mm-Pixel-Node-With-Waterproof-Connections-p/711-wp-blk.htm

I also bought pigtails from Holidaycoro http://www.holidaycoro.com/product-p/723-f.htm

I only used the male end (input) on the pixels and the female end on the pigtails (output)

Strips [male up 50 join to the next 50 down, female not used on the 2nd 50] Total of ten 100 pixel strips


Reply
Page 2 / 3
Share: