Construction Assist...
 
Notifications
Clear all

Construction Assistance

13 Posts
7 Users
0 Reactions
5,214 Views
Protege94
Posts: 556
Topic starter
(@protege94)
Honorable Member
Joined: 10 years ago
[#42685]

I am building my first mega tree and I am looking for a little insight.

It will be 10' tall and for year one it will only have 3 channels that will each have their own color of LEDs. (I will add more channels next year)

I am using 1 1/2" PVC with 1 1/4" PVC running inside of it to give it more strength and rigidity. My question is regarding the base. Should I build a base out of 4"x4" post wood or could I drive a piece of angle iron 3'-4' into the ground and then have 3' running through the PVC? If I did the angle iron route I would drill a few holes and bolt the PVC to the angle iron as well as run a few support lines.

Also, how does everyone do their circle at the bottom of their tree?

Any advice would be appreciated.


12 Replies
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Your pole: 1-1/4 EMT would give you great strength at ten foot

Here is what I did using 1/2" EMT as base and supports on my 1-1/4 " pole.

MTree

Reply
Posts: 205
(@barlav)
Estimable Member
Joined: 11 years ago

Here's how I did bottom ring for my 15+ foot tree:

01

It is 6 pieces of rebar pounded in about 2'. The ring is 1/2 conduit. The light strips hook to the hooks and the hooks can be tightened down for light strip tension. The ring is attached to rebar with pipe nipples and tees with "ears" chopped off. Nut/bolt through rebar and nipple hold it together. It is very solid but probably not the easiest to install.

Good luck!


Reply
Posts: 19
(@snooze091)
Eminent Member
Joined: 11 years ago

How would you recommend bending the 1/2" conduit? I'm also looking to create my first 10ft megatree this year.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
snooze091 wrote:How would you recommend bending the 1/2" conduit? I'm also looking to create my first 10ft megatree this year.

I got mine off craigslist for $8. It was a 3/4", but still works great on my 1/2"
Can look at ebay or amazon for something like this..... http://www.ebay.com/itm/Truper-Conduit-Pipe-Bender-12845-Thinwall-1-2-/400838407086?hash=item5d53d4b3ae:g:vRQAAMXQdwpRi2Mw

Real easy to use.


Reply
Page 1 / 3
Share: