Making a megatree with 12 lengths of 120 pixels each. Right now I have strings 1 and 2 tied together with power injection on the end of 2. Then strings 3 & 4, etc. That makes for a lot of wires running from the controller and power supply. Can I use a 3 core T type waterproof splitter (the middle is 2core) like Ray Wu makes, https://www.aliexpress.com/item/3-core-T-type-waterproof-splitter-the-middle-is-2core to tie the end of string 2 to power only using the middle connector, which is only 2 core, so gives me my power injection. And the other 2 connections, which are 3 core, would supply power and data to strings 3/4? This would cut down my cables from the controller/power supply from 12 to 7.
What you described in your post is basically what I am doing this year for a matrix that will consist of 30 strings of 120 nodes each---very similar to what you described just a different total number of strings... Based on reading here and other forums, watching a vid posted by David at HolidayCoro and some testing this year, I will power inject every 120 nodes. So, I will have 6 data/power outputs from my controller with the remainder 24 strings setup as series connections with power injections every 120 nodes. I am using my F16V2R to drive the matrix; it is capable of driving 680 pixels per output. I haven't actually tested yet (I guess I should!!), but I plan to have string #1 data/power from F16 with strings 2-5 in series with injection every 120, then string 6 data/power from F16 with strings 7-10 in series with power injection every 120, and so on... I am using Ray's 3 core power/data connectors along with his 2 core power injection tees (the black ones). I have tested that with some of the strings and it works well. I recommend testing the connectors before soldering; I ran into a few that had problems... Chased other stuff then determined the darned connector bad... Not knocking Ray; he is very reputable; just sharing lesson learned...
So you are saying you used that splitter from Ray Wu as I described in my originial post to supply power to 1 string and data and power to another and it worked fine? I tested with data on 1, 3, 5, etc and power on the ends of 2, 4, 6, etc and works fine. Now that I have to wire it all up on the frame I made I am trying to keep it simple and not have as many cables.
I have the Advatek Assistant so can only drive 2 strings, 240 pixels, with it. It does slightly more, I don't remember the number, but not enough for 3 strings of 120 pixels each. Would be nice to be able to drive 680 pixels like the F16V2R does but I guess with power injection I still need the cables for power so not too big of a difference with the number of cables needed.
Still lots of cables to run unfortunately. Yes, I am using the splitter and the black 3 core connectors from Ray this year. I plan to route 6 power/data cables from the controller to 6 strings (1/5/11/15/21/25) and wire up the remainder in series, with power injections to the remainder. I think I can keep it pretty neat that way; power/data routed from controller & fanning out to the 6 strings as noted, then power leads routed kind of at a 90 degree angle to the power/data cables to the power injection points.. Hope that makes sense. I haven't setup my PSUs yet; might be a bit of a trick "not to" have these looking too busy... Planning to use combination of CG-1500s and ammo boxes; I think I can hide the ammo boxes behind my medium Boscoyo minitrees...
Well I guess I need to order some up and try them out. Thanks for your input.
