Great! Makes things a little easier! What do you use to terminate the un connected ends of the pixel wires?
Kristian wrote:Great! Makes things a little easier! What do you use to terminate the un connected ends of the pixel wires?
Lots of different ways, but the simplest and cheapest....a dab of hot glue on the end of the wire run (preferably with the insulation flush to the copper)
Great thread to read...I had previously set up my similarly-designed mega tree earlier this year and tested it for several minutes to ensure it worked (24 strings, 360 degree, 100 pixels per output, 12 outputs from a E682, 2 12V 300W PSUs, brightness set to 50%). To seal the ends of the string I used that plastic/rubber dip stuff.
I didn’t even think of hot glue �� but that definitely sounds the easiest and quickest option!!
Thanks!
I run a very similar configuration and I agree that your configuration will work ... at reduced power.
All calculations ignore power requirements for the controller.
Total power required:
16 strings * 100 nodes * .05 amps/node = 80 amps at full power.
80 amps * 12 volts = 960 pixel watts at full power.
Power required per side of the controller
960 watts / 2 = 480 watts at full power
Power required per side of controller at lower output
480 watts * 30% power = 144 watts.
480 watts * 40% power = 192 watts.
It looks you could even run both sides off one PSU
960 watts * 30% power = pixel 288 watts (with 20% headroom on the 360 watt PSU even)
My personal learn by failure introduction to pixels:
My intro to pixels was: an e682, 16 strands of 50 node 12v pixels, and a 350 watt waterproof PSU packaged in a kit.
I built a 16 strand by 50 node 360 tree with all pixels and the controller on the same 350 watt PSU.
Everything worked with the various RGB single node chase test modes of the e682. Cool!
Then I tried full on white. The tree started strobing and I was not able to get it to stop. Terror!
I didn't do the math. I wasn't even aware of the math. I assumed the seller would kit up a PSU beefy enough to power the full setup at full power. Nope.
It took a while but I finally figured out I had power problems.
When I went to full on white, the controller was fine and sent commands to all nodes and the tree lit up full white.
The power requirement was well beyond the max the PSU could supply and the PSU shutdown.
The lights shutdown and the controller shutdown but the controller (or was it pixels?) remembered its (their?) last configuration (full on).
The PSU recovered and supplied power again. The controller came up and all the lights came on at full output for an instant and then went out again.
This cycle repeated very rapidly and the tree strobed while I tried to turn the off the test. It took several tries and was very scary for me.
As I diagnosed my problem, I learned a lot (mostly from reading here) about power requirements for pixels, power injection, wire gauge, etc.
Good luck!
