Mega tree wiring wi...
 
Notifications
Clear all

Mega tree wiring with E682

14 Posts
9 Users
0 Reactions
9,733 Views
Posts: 27
Topic starter
(@kristian)
Trusted Member
Joined: 9 years ago
[#49643]

Hi , I am planning to have a 32 string 360 degree tree, there will be 16 strands of 100 12v 2811 pixels split across 2 strings (50 nodes each drop)
I am planning to connect each strand of 100 pixels to each of the 16 outputs of a san devices e682 for both data and power. I will run the tree on 30-40% brightness. The e 682 will be powered by 2 350w psu’s.
My question is is this ok to setup like this??
Thsnks


13 Replies
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

My setup is somewhat similar and this should work fine.


Reply
Keebler
Posts: 1691
(@keebler)
Noble Member
Joined: 17 years ago
Kristian wrote:Hi , I am planning to have a 32 string 360 degree tree, there will be 16 strands of 100 12v 2811 pixels split across 2 strings (50 nodes each drop)
I am planning to connect each strand of 100 pixels to each of the 16 outputs of a san devices e682 for both data and power. I will run the tree on 30-40% brightness. The e 682 will be powered by 2 350w psu’s.
My question is is this ok to setup like this??
Thsnks

I have done similar things. I would encourage you to inject power at the ends of each of your runs. that way you will have the full color spectrum available.
i used to use a couple of the e682 boards for my mtree, but i quickly outgrew the boards...
injecting power is never bad thing


Reply
Posts: 27
Topic starter
(@kristian)
Trusted Member
Joined: 9 years ago

Great thanks, how do I inject power. I have purchased some t piece pigtails, will these work?


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

don't think you really need to worry about power injecting this since it is 16 strings of 100 12v each on its own port you should be find and doing it at lower brightness also helps


Reply
Page 1 / 3
Share: