I am starting to design my Mega tree (well not really mega tree) that is 10ft tall. what should my base diameter be? what if I decide on a 15ft tree, is there a calculation for this?
Thanks
Eric
According to my program, if hieght of tree is 15', then the tree ring diameter should be 7.5' feet.
John
I developed this online tool last year: http://altoonalights.com/mega/mega_calc.php It'll help with some of your calculations.
Ok, so I figured I would just post my question in this thread vs. creating a new one since it is on the same subject. My mega-tree this year is 20' and I used 3 pieces of 10' 3/4" PVC electrical conduit for my base ring. This should make it 5' from the center pole to the base ring. I am using 1" PVC T's around the ring and secure them to 1" pieces of PVC that I have in the ground. The problem I am running into is when I get to the last stake I have to pull really hard to get the base to stretch out and it looks warped...I took everything up and re-measured and tried again and I can't get it to look right...any ideas on what I could be doing wrong? Should I go smaller than 5'?
I doubt that it will make a *lot* of difference at night. So it's a little off here and there, with the blinky-flashy goin' on, nobody is going to care if it isn't down-to-the-millimeter perfect. It's like a sweatshirt -- if it covers your body, that's all it's designed to do. Doesn't have to be "fitted." 😉 You have to decide when over-engineering is starting to happen...
dhavard wrote:Ok, so I figured I would just post my question in this thread vs. creating a new one since it is on the same subject. My mega-tree this year is 20' and I used 3 pieces of 10' 3/4" PVC electrical conduit for my base ring. This should make it 5' from the center pole to the base ring. I am using 1" PVC T's around the ring and secure them to 1" pieces of PVC that I have in the ground. The problem I am running into is when I get to the last stake I have to pull really hard to get the base to stretch out and it looks warped...I took everything up and re-measured and tried again and I can't get it to look right...any ideas on what I could be doing wrong? Should I go smaller than 5'?
Well... my math says your "radius" should be around 4.77 ft, not 5ft, given a circumference of 30'. That could certainly be your problem. Why not get a length of string/rope about 6ft long and tie it loosely around your pole. Then measure out 4.77'. Now you should be able to walk the perimeter of the circle and stake your conduit in as many places as it takes, to get it to work.
(oh.. and .77 of a foot would be about 9.25 inches.. now you don't have to look it up like I did. 😉 )
ya I do need to relax a bit about things being just perfect, but you can definitely noticed that it is not right. I agree that it would probably go un-noticed by those watching the show at night, but what drives me crazy is the fact I know it isn't right. lmao (and I tell my wife she is the one with OCD..lol)
labrat, thanks for the info. That's how I measured the 5'. So I will make a mark at 4'9.25" and see how that goes. I was thinking it needed to be less than 5' based on looks but everywhere I have read and all the calculators said 5' so I went with that. I'll let ya know how it turns out. Thanks for the conversion of .77. I am not good with converting that at all. lol I made a big US flag to scale for the 4th of July and I drove myself crazy trying to get the decimal numbers converted to a measurement. lol
