I'm making bundles for my mega tree---white/red/green...
I'm stealing the end plug for use on my wiring harness...so I'm cutting it off of each strand....Yea, it's extra work, but I'll never be using it, and I have 11 conductor cable which I'm using to feed, so vampire plugs won't work as it's not SPT1 or 2....
My question is...since I'm removing the pass-through outlet, does it make sense to remove the second wire all the way back to mid-point of the strand (they're 100 count mini's)...or leave that wire in place for extra strength and support.
I've left it in place on the one's I've already done, but I'm wondering about the strength vs weight issue....removing the wire would remove about 15% of the weight of the strand, thus helping the load on the wires, but leaving it in place means 30% more strength...
I'm guessing strength is better, but has anyone else done this?
I think that third wire is important as it provides either the common or hot lead to that end of the plug (can't remember which...) If you took it out, I'm not sure the last half of the string would still work.
dirknerkle wrote:I think that third wire is important as it provides either the common or hot lead to that end of the plug (can't remember which...) If you took it out, I'm not sure the last half of the string would still work.
Seems to work as long as I leave in the 3rd wire on the first half of the strand...it's the parallel wire that runs to the chaining plug...right now I'm just wacking it at the plug end and sealing it off to prevent shorts or shocks...
Either way I think I'm leaving it in for strength (and it's a pain to completely remove it as it's wound in with the other 2 wires...I was just wondering if anyone else had considered this...
David
