Hi, I am building a new matrix this year with P5 panels and a colorlight receiver. The matrix is going to be 5x5 in size. What’s the best way to wire up the connections to the color light. Easiest would be using 5 of the outputs, one to each row of 5 panels. The other option I could do is use all 8 outputs with 3 panels each and the last one with 4 panels. That makes the wiring more complex with some longer ribbon cable runs in the middle. The last option is to use two colorlight receivers which would keep it at no more than 2 panels per output. Any input would be appreciated. Thanks
With the ColorLight protocol, there is one network packet per output display row so if you use 8 outputs and 64x32 panels then that is 256 packets per frame.
I would use 5 outputs at most but you could also use fewer which would reduce the amount of network activity on thePi/BBB side.
If you go over 497 pixels wide in a single output chain then that overflows a single packet and required two packets per line which negates any network savings by using fewer outputs. So if you do mix them up, don’t put more than 7 of your 64x32 panels on a single output. You can run outputs with different lengths, I run my first two outputs with 7 panels each and the second two outputs have 8 panels on them.
CaptainMurdoch wrote:With the ColorLight protocol, there is one network packet per output display row so if you use 8 outputs and 64x32 panels then that is 256 packets per frame.I would use 5 outputs at most but you could also use fewer which would reduce the amount of network activity on thePi/BBB side.
If you go over 497 pixels wide in a single output chain then that overflows a single packet and required two packets per line which negates any network savings by using fewer outputs. So if you do mix them up, don’t put more than 7 of your 64x32 panels on a single output. You can run outputs with different lengths, I run my first two outputs with 7 panels each and the second two outputs have 8 panels on them.
Thank you for the quick response. I had plenty of ribbon cable left from the previous matrix but was out of the ends. They just got here tonight so I’ll work on building it this weekend and will post some pictures. Thanks
