HELP...Bad Matrix p...
 
Notifications
Clear all

HELP...Bad Matrix panel?

4 Posts
2 Users
0 Reactions
6,773 Views
Posts: 7
Topic starter
(@jrodp)
Active Member
Joined: 11 years ago
[#52003]

Can someone tell me if this panel can be fixed or is it dead? Every other line is out! I bought these from Crockett Fantasy of Lights presale this year and had one panel with a dead pixel right out of the box, and if I remember correctly, another that did something similar to this one. Needless to say, I am not very happy with these panels now that this one has failed just days before Christmas! I had ordered one extra as a spare and CFOL sent me a replacement for the one with the bad pixel, but the enclosure is sealed up now and I would have to tear it apart to replace this one. I can actually get to the back of the panels and have checked cables and even tried one of the spares which worked fine. Is there anything I can do?

20191222 175603

3 Replies
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, I had a couple of panels that have done the same sort of thing (not the same supplier). I was able to fix mine as both turned out to be a poor solder joints. I’m just guessing now but looking at the fault you have there are four sets of 3 IC’s vertically positioned on the back of the board. If that is the case I would be looking at the (when viewed from the rear) middle IC on the left. Find something none conductive and stick it into a pencil sharpener to get a point and then whilst the board is powered up press down on each of the IC pins, hopefully this will complete a connection which will need to be soldered. Power off before soldering (sorry if that’s obvious) and let us know how you went on.


Reply
Posts: 7
Topic starter
(@jrodp)
Active Member
Joined: 11 years ago
Barnabybear wrote:Hi, I had a couple of panels that have done the same sort of thing (not the same supplier). I was able to fix mine as both turned out to be a poor solder joints. I’m just guessing now but looking at the fault you have there are four sets of 3 IC’s vertically positioned on the back of the board. If that is the case I would be looking at the (when viewed from the rear) middle IC on the left. Find something none conductive and stick it into a pencil sharpener to get a point and then whilst the board is powered up press down on each of the IC pins, hopefully this will complete a connection which will need to be soldered. Power off before soldering (sorry if that’s obvious) and let us know how you went on.

Thanks for the response, I will try that today and let you know.


Reply
Posts: 7
Topic starter
(@jrodp)
Active Member
Joined: 11 years ago

So I was not able to really test out the panel with the way it was mounted, but I was able to make enough room to slide it out and replace it with a good panel. I would like to see if could still get it to work though. Attached is picture of the back of the panel, do you know which IC might be causing the problem? Another thing I noticed before I replaced it, when I turned it on today, the rows that were working on this panel were much dimmer than the rest of the panels.

20191224 004738

Reply
Share: