Thanks Tim!
this is awesome tim thanks :), just what I had been looking for, Ive never used this software before, I have set it up, how would I execute the time function?
Thanks Stephen 🙂
If you run the LTC software in a command window without any parameters it give you a list of options....
* LEDTRIKS-C COMMAND LINE INTERFACE PROGRAM *
* BETA RELEASE 07/8/10 Tim Wells V0.10
This version can drive up to 2x2 TriksC/Ledtriks panels
USAGE: LTC [filename] command [filename] [command]
Commands:
#CLS = clear screen
#BLK = blank screen
#SHW = Show screen
#RL = Roll to Left (EDGE TRANSMISSION)
#RR = Roll to Right
#RD = Roll Down
#RU = Roll UP
#FRM = Whole Frame
#RPTxxxx = Repeat all xx times
#DLYnnnn = Wait nnnn ms
#LOOP = Repeat until keypress
#FDLnnnn = Delay between Frames nnnn (ms)
#HDLnnnn = Delay for Horizontal scroll (ms)
#VDLnnnn = Delay for Vertical scroll (ms)
#RDLnnnn = Delay for Rotate (ms)
#NPx = Number of active panels (1-4)
#TIME = Display time to execute this file
#ROTR = Rotate Clockwise (right)
#ROTL = Rotate AntiClockwise (left)
#RINCnnn = Rotation Steps (nnn degrees)
#RTOnnn = Rotation Angle (nnn degrees)
#RXCnnnn = Rotate Center X co-ord
#RYCnnnn = Rotate Center Y co-ord
#STA = Send TRIKS-C to stand alone mode
(until next command received)
#CALxxx = Coundown timer (2panels) xxx secs
#CLKxxx = Clock (1 Panel) for xxx secs
OR LTC [filename] with no params to run a script file
with 1 command per line)
There is more info in user guide on the Wiki
Tim
Ive double clicked on the LTC program and set it up, I'm on holiday and had to use a random com port but I cant see the CLKxxx function, I have attached a picture of what I can see. Is it just me that has this problem? Or does anyone else have it?
Thanks 🙂
:oops:ooops
Download it again and have a try Stephen... I uploaded the wrong .exe
The right Version 0.10 is now in the first post!
Tim
Thats it now 🙂 thanks tim 🙂
Finally got my led board set up and working, I cant seem to get the #clkxxx function to work, the diag led flashes but there is no output but I can use the countdown, any ideas what I need to do?
It's been a while.. but wasn't the countdown designed to go on two panels? In which case, perhaps you're jumper setting on the Trik-C is set for "the other panel". Can you double check the Trik-C is set for panel "1"?
(Again.. I may be completely off base here.. this all from a fuzzy memory)
The countdown function is fine, its the clock function that I cant get to work
Yes.. but if the countdown is writing to two screens (one and two)...
... and you are seeing one of them (for arguments sake.. lets say.. screen TWO)...
But the clock is only writing to ONE screen... (lets say... screen ONE)...
then you will get some stuff displaying for the countdown.. and not for the clock.
No?
