LED string repair
 
Notifications
Clear all

LED string repair

13 Posts
6 Users
0 Reactions
4,108 Views
Posts: 124
(@frankaz)
Estimable Member
Joined: 14 years ago

I did a similar design a few years back - but also had the resistor. I did mine for the good 'ol 2008 CDI LED "mess" to convert the strings from the explosive voltage doubled, to the split blob type. I did one as a test, drew up a tiny PCB, but never went further than that.

I am considering rebuilding my arches next year, so, I might consider going in. I will see if I can dig up my calculator, as I think I'd also based it on existing 50/70/100 strings.


Reply
michaelc
Posts: 1540
(@michaelc)
Noble Member
Joined: 19 years ago

I don't know if you eliminated the obvious yet, but I bought 3 cases of m5 LED's during the pre-sale from Creative Displays at the beginning of the year. All strings are good (so far) with one exception. On one string, the wire connection to the male plug end was broken. After looking at it and trying to see if the fuses were not contacting, one of the wires literally came out of the connector housing. I'm splicing on a new plug now.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
michaelc wrote:I don't know if you eliminated the obvious yet, but I bought 3 cases of m5 LED's during the pre-sale from Creative Displays at the beginning of the year. All strings are good (so far) with one exception. On one string, the wire connection to the male plug end was broken. After looking at it and trying to see if the fuses were not contacting, one of the wires literally came out of the connector housing. I'm splicing on a new plug now.

Actually I had a similar issue with one of my new CDI M5 strings this year....right at the plug..... Only upon close inspection the wire was actually pinched or cut......Paul sent me a replacement immediately (he's very good about that)...... The C6's I got 3 years ago are more problematic......seems every year I lose 2-3 strings..... I canibalized 1 string to use the LEDs for individual fixes.....but the ones with problems in the 'blobs' are the ones that are giving me fits.....I would like to figure out how to repair them...

This year....I tested all my mega tree stringers prior to putting them up.....had 3 bad strings.....then once I got everything installed.....another string went out....or at least half of it did.......Grrrrrrrr


Reply
Page 2 / 2
Share: