Cheap LED Strings
 
Notifications
Clear all

Cheap LED Strings

76 Posts
18 Users
0 Reactions
38.9 K Views
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I think I can help explain this board. I looked a these controllers a while back.

It looks like a standard full wave bridge so I don't know why you're only measuring 48 volts unless your meter is having trouble with rectified AC. It should be 170 peak.

The mystery board looks like a typical multifunction light controller. I have a schematic of one these somewhere. It's basically a microprocessor.

The 150K resistor is just a current limit that's likely going to a zener on the micro board. You'll probably measure 5 VDC on the cap.

The 2 meg resistor is a current limit for the zero crossing input. The voltage is clamped by the internal protection diode.


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I wish I knew, Henri. You say the circuitboard is the same for your voltage -- I suspect if that's the case, soldering the anode to the cathode of the SCR would work and light them all simultaneously because all that does is bypass the SCR's gate and lets the electricity flow directly out to the lights.


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
ErnieHorning wrote:I think I can help explain this board. I looked a these controllers a while back.

It looks like a standard full wave bridge so I don't know why you're only measuring 48 volts unless your meter is having trouble with rectified AC. It should be 170 peak.

The mystery board looks like a typical multifunction light controller. I have a schematic of one these somewhere. It's basically a microprocessor.

The 150K resistor is just a current limit that's likely going to a zener on the micro board. You'll probably measure 5 VDC on the cap.

The 2 meg resistor is a current limit for the zero crossing input. The voltage is clamped by the internal protection diode.

Ernie, that makes an awful lot of sense. I'm truly puzzled on the voltage measurement too - and I tried two meters! Maybe it's some bad karma kicking in...


Reply
Posts: 42
(@riri7707)
Eminent Member
Joined: 17 years ago

You are right,
I shortcut like in the picture, and it works...
All 4 outputs stays now on, overpassing the controller...
Cheers... Henri


Reply
Posts: 255
(@frankv)
Reputable Member
Joined: 17 years ago

I also checked out the voltages and so on... mine (being in NZ) have 230VAC going into and out of the controller.

I keep an eye on the online auctions to get these strings cheap too... I aim to buy at NZ$1 per metre or less. You do have to watch... some of the strings are only 2 circuits, others are 4. Also the controller is usually close to the first LED and is NOT waterproof, which makes them a bit impractical for exterior use.

What I've done is to throw away the controllers altogether and hook the strings up to my newly-built Renard24 board.


Reply
Page 3 / 16
Share: