dirknerkle wrote:What voltage did you give the lights after building the fw rectifier?
Well When I brought the lights then I brought 220 - 230 VAC light, so I am giving the rectifier 220 - 230 VAC 😉
christmas-light wrote:Well When I brought the lights then I brought 220 - 230 VAC light, so I am giving the rectifier 220 - 230 VAC 😉
But what voltage is going to the strings?
220 - 230 VDC 😉 sorry 😳
Here's the little controller circuitboard from the inside of one of these gizmos -- both top and bottom are included. I've drawn-in the components over the bottom and have provided some values. The capacitor is just 4.7uf probably to smooth out the power to the ??? component (the mystery piece). It's probably some sort of CPU or timer -- there's no way to know what the heck is in there as it's just a small blob of epoxy on a small circuitboard that's soldered into the main board. Ignore the handwritten marks on the bottom of the board -- I was just isolating solder pads with top components.
The 1N4004 diodes obviously form the rectifier circuit, and the two resistors are 2meg ohm and 150k ohms. The pushbutton switch just toggles the mystery component into a different blinking/dimming sequence.
For the board to deliver 46vdc to each of the four individual light circuits, I'm thinking the resistors and the mystery component must form some sort of voltage regulator or voltage divider.
Any ideas out there???
Hi,
I have exactly the same strings and controler, but the voltages are not the same for mines.
I have 220v AC in and each output is 220v DC.
for each channel.
The strange thing, the capacitor is not always wired the same way polarity between different boards...
I got 60 units (15 red/15 green/15 blue and 15 white) for $5 per unit...
all colors are bright, except the red ones( not enough britness)...
From the 60 units, one burned after 2 minutes, but it was my fault as i made the test with the string rolled and not deployed. 2 of them have a pb with one part of the string (1 channel faulty).
Can we do the modification to light alll channels same time, without any PB?
thanks
Henri
