Still no luck, changed them to run from channel 1 on universe 1 then filling the full universe but still nothing. Is the link lights suppose to light up on the ether-node?
mlevings wrote:The problem is with your e682 configs. Start with universe 1 channel 1 on each board and go up from there. Don't try to get the channels to match up with your ethernode channel numbers. Fill each universe up in order as needed.
This is correct. The Helix Network Supervisor Channel Map is used to map the Vixen Channels to your Hardware. For example in your Left Front Garden (Socket 1) DMX Universe 1 you are mapping Vixen Channels 129 to 368 to DMX Universe 1 Channels 1 to 240. So Vixen Channel 129 would map to DMX Universe 1 Channel 1, 130 to 2...
Another thing that might be a problem is the total number of channels you are using. While my initial speed tests with the microSD card showed that I should be able to support 48 DMX Universes on each Ether-Node board the initial tests of the actual firmware started having problems after about 12-15 DMX Universes. I tweaked/fixed some bugs in the firmware after I started having those problems but didn't have time to go back and do another stress test. I have plans for next year to modify the microSD code to work more like DMA. This should speed it back up. I'm not sure how many total Universes you plan to use this year (the screen shot for Socket 2 wasn't uploaded), but if you are getting near 12 then I would be concerned.
The third thing to check is make sure the Unicast mode is selected on each of the E682 boards. Your screen shots have this area cut off so I can't be sure that is set correctly.
Thanks Guys, Have done that, checked all boards are running Unicast. I'm using 1 universe 279 Channels on Socket 1, 1 universe 492 channels on socket 2, and 3 universes up to 477 on the 3rd channel on socket 3. Going to try and scale it back to only socket 1 to see if that will work.
Thanks guys for your help, all up and running now. I need to slap myself I forgot to put on the two jumpers on the ether-node on the prop plug.
Once again such a great site and helpful people, and once again thanks to Greg for all his hard work this year.
Ryan
Greg,
Just wanted to say thanks again for the great controller and the continual improvements.
Already looking forward to more pixel fun next Christmas.
Bryan
