Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago

Couple of questions:
1. Is the board compatible with the E1.31 bridge?
2. Can the Xbee handle the ammount of data generated needed by pixels?


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago

In addition to the above, do you have to connect through a router or switch or can you direct attach the two?


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

OK, time to cry uncle.

Probably something simple but I'm not getting my pixels to work off of my Ethernode board.

I have a V3 Main Board, an Ether-Node board, a network switch and two E682's.

Main Board lights - AI-Slow blink, TX-Flashing, Wireless Enabled-ON, Show Running-ON, Heartbeat- Slow Blink, all others off.
Ether-Node Board lights - 100-ON, Link-ON, AI-Fast Blink, RX-Solid, Wireless-ON, Heartbeat-Beating, Socket 1 Enabled-ON, Socket 2 Enabled-ON.

Main Board Configuration

Helix Main Board

Ether-Node Configuration for E682 No. 1

EtherNode E682#1

Ether-Node Configuration for E682 No. 2

EtherNode E682#2

E682 No. 2 Configuration

E682 #2

I didn't attach E682 No. 1 configuration, since I don't have it handy, but it starts with Universe 1, Channel 1 and goes up from there.

I've tested the lights with the E682 with test patterns and the lights/E682 work.

So what am I messing up? This seems to be similar to what I did last year, except more pixels. Help would be appreciated.


Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

blantrip,
It looks like you are skipping from universe 2 channel 390 to universe 3 channel 1 on your e682. Change the third row to start at universe 2 channel 391 and go up from there to match your ethernode config. You need to fill each universe with 510 channels like your ethernode config. I'm guessing that is not all of your issue if you are not getting any pixel output. I switched to fpp this year so my helix setup is retired after only 1 year. I had no issues last year running 1200 pixles on helix though.


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

Thanks for the suggestion. I agree it seems like I should get some pixels so there must be something else but I'll incorporate your suggestion and see.

Do you use any non-pixel lighting with your FPP setup? I did buy a rasppi and have played with FPP but didn't see how I could incorporate my SSR based light items, at least not without investing in some other platform.


Reply
Page 10 / 22
Share: