Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 410
Topic starter
(@gmbartlett)
Honorable Member
Joined: 19 years ago
blantrip wrote:Greg,

While using the latest HNS and running the Upload Wizard I'm getting the following error:

Any ideas?

Bryan

As mentioned in the Helix and Vixen V3 thread, the output module isn't capturing all of the intensity values for each event. Tony and I think it is taking longer than the event period to save the values. So if you are using a 50 ms event period, it might actually be taking 65 ms to save the intensities. This means that it is actually missing about 1/3 of the events. Tony is aware of this problem but I don't know if he has had any time to work on the problem.


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

Thanks. Understood. I didn't recognize the post in the other thread you mentioned was with the same error I was receiving since it discussed an SOS code.

On to Vixen 2. Thanks to you and Tony for getting us as far as we are. I recognize it's a busy time of year for us all so thanks for the replies.

Bryan


Reply
Posts: 31
(@cullen-ryan)
Eminent Member
Joined: 14 years ago

Hi All, just having a few issues with my ether-node setup. Have gone through and done a test sequence in vixen 2, uploaded the files through supervisor v3.2, all the Helix Daughter boards work but nothing on the ether-node.

My setup is one helix main board controller running 4 32ch daughter boards, one ether-node board wired linked running three E6804 boards.

In the channel map I started the first pixel board at channel 129. See attached image.

I have noticed that on the ether-node board they first 3 sockets are enabled but not linked. Was wondering if that is the problem.

Any help would be greatly appreciated.

Regards

Ryan

MainBoardChannelMap
Socket1
Socket1
Socket3
1stPixelController
2ndPixelController

Reply
Posts: 31
(@cullen-ryan)
Eminent Member
Joined: 14 years ago

And the 3rd Pixel Controller Setting Page

3rdPixelController

Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

The problem is with your e682 configs. Start with universe 1 channel 1 on each board and go up from there. Don't try to get the channels to match up with your ethernode channel numbers. Fill each universe up in order as needed.


Reply
Page 8 / 22
Share: