Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago

The Bridge does not respond to the ethernode. It does work perfectly when I direct attach it to my computer. I can run sequences on it and change its configuration.


Reply
Posts: 947
(@warlock)
Noble Member
Joined: 19 years ago

Ok so it is the connection on the node or the signal going to it. Can you go from your mainboard to the node and see if it is the signal or the node. In other words remove the bridge from between then and see if that generates an error file on either board. Cause if there is an erroe it should generate the file. Also check on your cards to make sure ypu don't have a bug I found which was thw files did not transfer correctly and some werw left empty


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago
Ok so it is the connection on the node or the signal going to it. Can you go from your mainboard to the node and see if it is the signal or the node. In other words remove the bridge from between then and see if that generates an error file on either board. Cause if there is an erroe it should generate the file. Also check on your cards to make sure ypu don't have a bug I found which was thw files did not transfer correctly and some werw left empty

I removed the Xbee radio from the ethernode during show execution to try to generate an error file. No such luck.


Reply
Posts: 947
(@warlock)
Noble Member
Joined: 19 years ago

Strange. Try taking out the bridge and go with the node directly to your Helix mainboard. By going direct you should generate an error file. Also make sure your second xbee is set up different frpm the first so there are no communication issues


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago
Strange. Try taking out the bridge and go with the node directly to your Helix mainboard. By going direct you should generate an error file. Also make sure your second xbee is set up different frpm the first so there are no communication issues

Still no error file. and the Xbee setup is good. I am out of ideas at this point.


Reply
Page 17 / 22
Share: