Spot Light Issue...
 
Notifications
Clear all

Spot Light Issue...

2 Posts
1 Users
0 Reactions
1,610 Views
Posts: 934
Topic starter
(@superfreak3)
Noble Member
Joined: 19 years ago
[#53168]

Hi there,

First, let me start off by saying what does work. Full disclosure, I'm small scale and old school.

I have a v2.5 Ren24 board and a v3.0 Ren24. There is a comm out/comm in connection from the 2.5 to the 3.0 board. On the 3.0, comm out to the spotlight (DIYC spot, I believe). That all works fine. The serial connector I'm using is v2.5 as that's the first board in the chain. This all works fine and the spots are good.

I wanted to do away with the v2.5 board and just use the 3.0. When I hook the comm/out from v3 to the spot, all the spot colors come on steady with no adherence to the actual sequence UPDATE: the spot in this scenario seems to respond to ramps and fades, just all colors at the same time. Here, I have a v3.0 serial connector.

So, what I tried next was using just the v2.5 board, comm out to the spot, but in this scenario, the spot doesn't even light at all.

It's been so long ago that I set this up, I'm not sure if there was any special configuration needed on the boards themselves or not.

I can use either board, whichever I can get to work. Any ideas as to what might be going wrong? I hope someone can help me so I can finish setting up, but I fear the 'stuff' I'm using might be too old and forgotten.


1 Reply
Posts: 934
Topic starter
(@superfreak3)
Noble Member
Joined: 19 years ago

I guess I could just go with the old 2 board configuration and and just use the v3 board as one big gateway to the spots. I'm only going to be using about 1/2 the channels of the first, v2.5 board.


Reply
Share: