RGB Strip Controlle...
 
Notifications
Clear all

RGB Strip Controller

1 Posts
1 Users
0 Reactions
1,224 Views
Posts: 12
Topic starter
(@tehphreakshow)
Eminent Member
Joined: 18 years ago
[#53204]

Found a couple of these lying around with a bunch of RGB DCSSR's and thought I might put a couple together and add some dumb strips to the display. Used the latest firmware I could find for these (RP-24-strip-pwm-57600) and ran into some issues with it...

Used Vixen 2 for testing purposes and found channels all over the map. 1-3 working fine, but everything else is a mess... Cannot even get a signal from channels 10-12, other channels map to RG or B on an entirely different RJ-45 jack. One of the boards has PIC that programs/verifies just fine but does not work - even when put into a known working board.

At this point, I know the boards are all good, because I have tested them with a PIC that functions (albeit not 100%). Pretty sure it's a firmware issue, although I have read other posts on this board with the same channel 10-12 not working issue.

Boards are all v3_02092014 and DCSSR's are v1b_02052014 so I am pretty sure that's the latest versions...

Any help is most appreciated!


Share: