Activity
 
Notifications
Clear all
Superfreak3
@superfreak3
Noble Member
Joined: Jan 10, 2008
Topics: 126 / Replies: 808
Reply
RE: Best Clips for a Grid Drop Ceiling....

I forgot to post that I purchased these and they worked perfectly!

1 year ago
Forum
Topic
Forum
Replies: 2
Views: 8298
Reply
RE: Looking for Renard AC Controller boards

Superfreak3 wrote: I have two Renard 24 controllers, both with power leads and one is in an enclosure if you're still interested.

2 years ago
Reply
RE: Looking for Renard AC Controller boards

I have two Renard 24 controllers, both with power leads and one is in an enclosure if you're still interested.

2 years ago
Topic
Forum
Replies: 2
Views: 1202
Reply
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

P. Short wrote:Take all of the socketed IC's out of their sockets and then re-insert them. This may be enough to break through any corrosion on the I...

4 years ago
Forum
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

I hooked up the working Renard 24 and all is fine. Swapped out for the SS8, no blinky flashy. I tested all baud rates in in the profile for both of ...

4 years ago
Forum
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

ctmal wrote:It sounds to me like WakeFan is probably on the right track. Plug in one of your working boards to make sure you have the serial setup wo...

4 years ago
Forum
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

WakeFan wrote:They should respond for channels 2,5,6,7,8 as they are turned on and off. I would try COM port settings in your software. Serial adapt...

4 years ago
Forum
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

So if the diagnostic LED jumper is on, should any of those be lit other than the power before I even run a sequence. They are all off and none respon...

4 years ago
Forum
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

MikeKrebs wrote: This should help. It's been so long since I had to worry about the boards I used in my small show. I'm sure I'll have tons of que...

4 years ago
Forum
Topic
Replies: 0
Views: 734
Page 1 / 63
Share: