Activity
 
Notifications
Clear all
Superfreak3
@superfreak3
Noble Member
Joined: Jan 10, 2008
Topics: 126 / Replies: 808
Reply
RE: Channel String Max Question(s)/Discovery...

The Snubbers work great! THANKS to all those who lent a hand!!

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

One other question, and it may have been mentioned earlier, but does it matter where in line the snubber is located. Does it have to be at the beginn...

6 years ago
Forum
Reply
RE: Spot Light Issue...

I guess I could just go with the old 2 board configuration and and just use the v3 board as one big gateway to the spots. I'm only going to be using ...

6 years ago
Forum
Topic
Forum
Replies: 1
Views: 1606
Reply
RE: Vampire Snubbers

Wayne J wrote: OH man, that is sweet! I just finished making 16 with the plug. I think I'll use your suggested solution on the main channel output...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

MartinMueller2003 wrote:In my experience, epoxy has better heat transfer characteristics. Silicon tends to be a heat insulator and what you want is a ...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

rayhjr wrote:I'm late to this but you might want to try adding the resistor to the output of the controller or at the beginning of the string instead ...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

MartinMueller2003 wrote:If the guts of the plug are a solid block of epoxy, then the heat from the resistor gets transferred through the epoxy to the ...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

algerdes wrote:No air gap needed. The silicone will transfer the heat to the shell, where it should dissipate into the surrounding air. Thanks ever...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

algerdes wrote:Snubbers tend to get warm while in use. It is the function of the resistor that causes this. Just make sure the mount you use, whethe...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

MartinMueller2003 wrote:fill it. make sure the entire plug has good ventilation. The silicon is going to turn the whole plug into a heat sink. When ...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

So I was looking at a thread using vampire plugs to create the snubber and was warned to allow for heat ventilation from the snubber. In the PlanetCh...

6 years ago
Forum
Reply
RE: Vampire Snubbers

Xenia wrote:Using 440 C soldering stand soldering upright aqainst the piercing leg and on the resistor wire. (this is the same method I use on triacs...

6 years ago
Forum
Reply
RE: Vampire Snubbers

Wayne J wrote:Save some money and just put the resistor on the channel terminal. 🙂 I know this is old, but how would you do that? Could you provid...

6 years ago
Forum
Reply
RE: Channel String Max Question(s)/Discovery...

Everything is ordered. We'll see how this works out in a week or two! Thanks for all of the help and hopefully this solves/works around the problem.

6 years ago
Forum
Page 2 / 63
Share: