Quick SS8 Assembly ...
 
Notifications
Clear all

Quick SS8 Assembly Question

15 Posts
8 Users
0 Reactions
4,889 Views
james70818
Posts: 2045
(@james70818)
Noble Member
Joined: 19 years ago

The Wiki for them is very good. If you have multiple boards to do I would do one first and see what you run into. Me I install all of the flat stuff first. The wiki puts the caps and voltage regulator in too early. Just my opinion and as you do yours, you will find what works best. The SS series is a simple and straight forward board. Good Luck and keep us posted.

James


Reply
Posts: 934
Topic starter
(@superfreak3)
Noble Member
Joined: 19 years ago

I'll definitely post on my progress (or lack thereof) as soon as I get started. I would think that this can be completed in one sitting, but that might be biting off more than I can chew. I probably won't try to get it done all in one shot as I probably won't have one dedicated chunk of time away from the home chaos.

What is a realistic time of completion for the SS8! Experts and newbs can chime in on this.


Reply
dirknerkle
Posts: 10311
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

One of the most important things happens when you're done. You're going to want to plug it in and fire it up. RESIST THE TEMPTATION TO DO THAT!

Instead, check every solder joint, make sure there are no shorts or splattered solder around anywhere, and check and double-check the orientation of the components in their sockets. Only after you're satisfied that everything is in its rightful place and the board is clean should you apply any power to it.


Reply
Posts: 95
(@cessnapilot)
Trusted Member
Joined: 18 years ago

I just finished my first SS16 board. It took me about 4-5 hours to assemble it, I think. The only other boards I had assembled were 2 SSRoz's, however, I did have some previous soldering experience just nothing of this scale. It took me about 1 hour to go through the Beginners Setup Guide. One thing to keep in mind if you have the diagnostics PIC chip is the note about the differnernt baud rates. I couldn't figure out why I was getting the FE LED to light up because I had the baud rate at 57600 instead of 19200.:oops:


Reply
Posts: 934
Topic starter
(@superfreak3)
Noble Member
Joined: 19 years ago
dirknerkle wrote:One of the most important things happens when you're done. You're going to want to plug it in and fire it up. RESIST THE TEMPTATION TO DO THAT!

Instead, check every solder joint, make sure there are no shorts or splattered solder around anywhere, and check and double-check the orientation of the components in their sockets. Only after you're satisfied that everything is in its rightful place and the board is clean should you apply any power to it.

I will definitely keep that in mind as I'm sure I'll want to fire it up right away!!


Reply
Page 2 / 2
Share: