Problem with Ren64x...
 
Notifications
Clear all

Problem with Ren64xc...

4 Posts
4 Users
0 Reactions
1,806 Views
Posts: 12
Topic starter
(@azcomp)
Active Member
Joined: 16 years ago
[#17179]

I built a Ren64XC and performed all the diagnostics and everything seems to checkout. I used both diag firmware, plus a manual check for each channel. All is good, but when hooking up the serial cable from the computer, I can't get any lights to light up. No lights on the Ren64 come on except the power light. Any suggestions? I did try to go straight from the serial from the computer to the RJ45 also, but that didn't seem to work either. I connected DE9 pin 3 to RJ45 pin 4 and DE9 pin 5 to RJ45 pin 1. Same behavior as with serial connection.... Nothing.


3 Replies
DaveJZ
Posts: 974
(@davejz)
Noble Member
Joined: 16 years ago

Make sure your serial is set to the correct com in vixen. I would also make sure that your settings are correct: 57600,data bits 8,parity none, stop bits 1. Unless you did something different when programming your pics.

You'll need to also make sure you have the channels set for the ren and that the renard plugin is checked.


Reply
TimW
Posts: 554
 TimW
(@timw)
Honorable Member
Joined: 19 years ago
AZCOMP wrote:I did try to go straight from the serial from the computer to the RJ45 also, but that didn't seem to work either. I connected DE9 pin 3 to RJ45 pin 4 and DE9 pin 5 to RJ45 pin 1.

Try connecting DE9 pin 5 to RJ45 pin5 as well.... - the input signal needs to be seen across pins 4 and 5. Check out the diagrams on the wikito check.

Make sure your serial cable is a straight through cable (pins on each end connect to the same position - 1-1,2-2,3-3 etc...)

Other reasons the lights might not come on.

- No zero cross (if using AC pwm)
- Wrong com port/output plugin assigned in vixen (as per previous post)
- If using a cheap usb-rs232 dongle, some have inverted (ttl) outputs so won't work.


Reply
ChiefWarrant
Posts: 570
(@chiefwarrant)
Honorable Member
Joined: 19 years ago
DaveJZ wrote:Make sure your serial is set to the correct com in vixen. I would also make sure that your settings are correct: 57600,data bits 8,parity none, stop bits 1. Unless you did something different when programming your pics.

You'll need to also make sure you have the channels set for the ren and that the renard plugin is checked.

+1

Ran into that problem...trying to testing 160+ channels, but only had 64 configured.


Reply
Share: