Multiple controller...
 
Notifications
Clear all

Multiple controller problems

13 Posts
5 Users
0 Reactions
4,306 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
[#17183]

Here is what I have.

1 Renard 24(fkostyun) and 4 Renard24ss.
I am using all my same cables at this point. I put the Renard24 first that seems to work ok but I do not get much after that. All my controllers worked on the test bench independently. If it helps I purchased the Renard24 I was not the 1st in line. Do I need to change the jumpers? On the 2nd controller I have no jumpers and the other 3 have jumpers on 1 2 3. I am still trouble shooting any Ideas would be cool.

Thanks
John


12 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 19 years ago

Remove JP1 jumpers on the SS boards.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

If I recall right, some versions of the fkostyun boards have pins 4,5 reversed from those on the Ren64 and Ren-SS boards. If your Renard16 board is one of those, you need to make sure that your interconnect cables take this into account.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

So which interconnect should i change, the incoming to the 1st controller or the out to the 2nd?

Thanks
John


Reply
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 19 years ago

I have the same problem ,seems the output on the ren24 isnt working on mine.
I just put it last in the chain all is well


Reply
Page 1 / 3
Share: