Multiple controller...
 
Notifications
Clear all

Multiple controller problems

13 Posts
5 Users
0 Reactions
4,318 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

I may just do that since my last controller is not hooked up yet. Just this ren24 is for the mega tree and kinga burried if I can just change the pin setting on my DB to rj45 then I guess I will have to change the out as well I think just not too sure on that yet. Lastly if I do put the ren24 last can I keep the current cat 5 I made for the ren24 ss? I am kinda stumpped here. I just hope to fix this tonight. I have family in town and I really wanted to show them after dinner tomm.

John


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

I just have one more thing on thing on this, All my cables were made for the ren24ss. Now I add the ren24. So my cables were made 1,2 4,5. Do I change the incoming into the ren24 or the output from the ren24 to the ren24ss. If I am correct if I reverse 4,5 from the out on ren24 to the in on the ren24ss would that work. I just hate to move around controllers at this point. Sorry to keep bugging on this I just cannot find a good ans.

Thanks again
John


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago
olingerjccj wrote:I just have one more thing on thing on this, All my cables were made for the ren24ss. Now I add the ren24. So my cables were made 1,2 4,5. Do I change the incoming into the ren24 or the output from the ren24 to the ren24ss. If I am correct if I reverse 4,5 from the out on ren24 to the in on the ren24ss would that work. I just hate to move around controllers at this point. Sorry to keep bugging on this I just cannot find a good ans.

Thanks again
John

There was differences in the cables at one point on the Ren24 (not SS) check here for your board version and wire accordingly.....
http://www.doityourselfchristmas.com/wiki/index.php?title=24_Channel_Renard_with_SSR_Assembly_Instructions#PC_to_Renard_Cable


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
Wayne J wrote:There was differences in the cables at one point on the Ren24 (not SS) check here for your board version and wire accordingly.....
http://www.doityourselfchristmas.com/wiki/index.php?title=24_Channel_Renard_with_SSR_Assembly_Instructions#PC_to_Renard_Cable

ok i wii try that, now can the out stay the same 1,2 4,5

Thanks
John


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

I have one more folloow up with this, with the DB connector I cannot get 3 wires to go up the connector. I bought the crimp on kind. My question is if one goes all the way in but the other 2 are touching the wire will that work or do all 3 need to go all the way in. Hope that makes sence.

Thank you
John


Reply
Page 2 / 3
Share: