I am trying to get my Ren4Flood/DIYCFlood daisy chained with my RenardSS16. I have the SS16 attached to the computer serially and working successfully. I attached the Ren4Flood to the SS16 via cat5. No jumpers set on the Ren4Flood and used channels 5-8. It is running on a 18v wall wart. The result is that I only get some of the LEDs to light: 7 reds, 3 blues, and 3 greens.
I tested the DIYCFlood when I built it a few months ago and all the LEDs worked back then. I just now detached the DIYCFlood form the Ren4 and tested the LEDs manually and I had the same problem as above except I lost one more red LED.
Thinking back, I had a bad Ren4Flood that did not worked very well attached to the DIYCFlood and I am wondering if I "blew" most of the LEDs with bad board.
Can I fix this?
The schematic I saw for the REN4FLOOD uses a transistor as a switch to ground. I would not suspect it to be the problem. The DIYCFLOOD board has a constant current source. Is it possible that your 18V supply is too high and your constant current chip can't handle the heat? LED destruction is mainly due to too much current flowing through it.
Hmm - I run mine at 24v so 18v should not be a problem. The CC chips do get pretty warm at 24v but I ran them during testing for 2 days straight. It was good to remove the Ren4 from the equation. Unfortunately, there isn't much in the path - 3 LEDs and a CC chip in series - that's it... I don't think even having reverse voltage would do any damage since the LEDs (which are still diodes) would block the flow -- but I'll ask anyway - - is it possible the supply was reversed at some point?
Are you asking if I swapped the negative and positive leads on the power supply? I don't recall of the top of my head but that is quite possible.
I should also mention that the whites do not work at all now and they all did went it first built the flood.
Do you have an led tester?
Well - like I said, I don't *think* there would be damage but then again I haven't tried wiring it backwards to test. I can't think of any reason why this would happen otherwise...
Not knowing the history of your board, is it possible that you have the wrong CL2 devices? Could you be having the CL25 by mistake? The CL25 is a 25mA CC source as opposed to the 20mA CC source.
Your photo in the your 1st post looks odd. The 3rd row from the left you have 1 red LED on. Yet the same current is flowing through two defective red LEDs above it, or they are shorted out. Are your solder connections good from a visual inspection?
I'm just using the BOM that came with the boards in the Group Buy. When I first built the DIYCflood board - back in the summer - all the LEDs worked when I tested it directly. This was before I hooked it up to my first Ren4Flood. I had some problems with my first Ren4 that I could not figure out. While debugging the problems I hooked up the Ren4Flood to the DIYCFlood and could never get it to work.
So I built a second Ren4 that came out, as far I can tell, just fine. Last night was the first time I tested it with the flood and got the few LEDs.

