Renard Question ..
 
Notifications
Clear all

Renard Question ..

5 Posts
4 Users
0 Reactions
1,983 Views
Posts: 87
Topic starter
(@jammerone)
Estimable Member
Joined: 17 years ago
[#21804]

Hello there mates ,,

Just ask ..

I have REN64XC it is possible if I will use 1 to 4 channel socket to 2pcs SSR?

I am planning to parallel connection from 1 slot from controller to 2 pcs SSR

caue I am planning to make a mirroring effect ..

Regards,


4 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

You can split any channel to as many outputs as you need except the sink/source current on any pin can't exceed 25ma, and the total sink/source current on the chip for all pins can't exceed 95ma. Just do the math.


Reply
Posts: 87
Topic starter
(@jammerone)
Estimable Member
Joined: 17 years ago
dirknerkle wrote:You can split any channel to as many outputs as you need except the sink/source current on any pin can't exceed 25ma, and the total sink/source current on the chip for all pins can't exceed 95ma. Just do the math.

I dont have any idea about this sir ,

hope you can help me .

Regards


Reply
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago
Jammerone wrote:I dont have any idea about this sir ,

hope you can help me .

Regards

There is a limit to how many ssr's you can connect to each port. You would have to do the math for the components on the board.
What about copying the channel you want to parallel to another channel? Let's say, program channels 5-8 the same as 1-4. That way you wouldn't have to worry about how many ssr's you have connected to the port, there would only be one connected.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

You could certainly run two SSRs off of one set of outputs, but beyond that you would want to calculate. In the casecof the the ren64, the status LEDs are an additional current draw. my recommendation would be to not go more than that and don't do it on every output.

Basically, the PICS can only handle a fixed amount of current drawn through them. Each SSR channel is another Led in addition to the status LEDs. Another concern would be that the Power supply can supply enough power to reliably drive all the logic and LEDs.


Reply
Share: