Notifications
Clear all

picap set up

10 Posts
4 Users
0 Reactions
4,355 Views
Posts: 347
Topic starter
(@pcguy17)
Reputable Member
Joined: 9 years ago
[#54575]

hi everyone.
I just got my picap for my raspberry pi and i want to make sure i don't fry something
So leave all 3 jumpers in place if i want to use a 12 volt power supply and to power the pi also
also on the DMX /LOR side jumpers that is only for if i plug a Ethernet cord into the port on it?

Don't normally these things come with a battery? mine didn't so had to order some from amazon they came today would like to play around with this thing and see if i can get it working.


9 Replies
Posts: 120
(@superdave)
Estimable Member
Joined: 13 years ago

Is this the Falcon version? A couple different people have made PiCaps. If it is the Falcon one, you can check out the Unofficial Manual


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi, if you use DMX the FPP settings are:

Output type is DMX-Open
Output Config Port is ttyAMA0

I recently had to look around for them the documentation didn’t make them obvious.


Reply
Posts: 347
Topic starter
(@pcguy17)
Reputable Member
Joined: 9 years ago
superdave wrote:Is this the Falcon version? A couple different people have made PiCaps. If it is the Falcon one, you can check out the Unofficial Manual

I ordered it from https://www.pixelcontroller.com/store/

Thanks for that link. that is the best picture i have seen yet.
guess to be safe will just take off the 1st jumper and just power both units.
then i will leave 12 34 pin jumpers in place cause i will be using a 12 volt power supply, i have 12 volt pixels.

I don't plan to use the RJ-45 port i don't guess. I will be able to use my regular USB 485 plugged into the raspberry pi for my LOR controllers?
or will i have to use the RJ-45 to plug the Ethernet into for the other controllers?


Reply
Posts: 347
Topic starter
(@pcguy17)
Reputable Member
Joined: 9 years ago
Barnabybear wrote:Hi, if you use DMX the FPP settings are:

Output type is DMX-Open
Output Config Port is ttyAMA0

I recently had to look around for them the documentation didn’t make them obvious.

All of this stuff still confuses me a little. if i have to use the RJ-45 poer it will be ran to my two LOR CBT16 boxes so i would need it on the LOR setting correct?


Reply
Page 1 / 2
Share: