FPP Shutdown Script
 
Notifications
Clear all

FPP Shutdown Script

5 Posts
1 Users
0 Reactions
3,598 Views
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago
[#54570]

I've seen on here people mention a shutdown script for your FPP controller, in my case a Kulp K8-PB. I wanted to shut my controller down after the show was over then cut power to my whole display as to not constantly run voltage through the pixels. Are the FPP scripts found on the Github site? ( https://github.com/FalconChristmas/fpp-scripts/tree/master/System ) if not could someone direct me to them?

Additionally, thinking this through, if I shutdown the Kulp board and then cut power to the entire display the board should start back up the next day when the power is turned back on right? or do I need another script to start the board back up?

Thanks
-Russ


4 Replies
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago

Perfect thanks so much!

-Russ


Reply
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago
MikeKrebs wrote:Go to content setup
Script repository browser
Find Shutdown.sh
Click install

Now go to your playlist
In the lead out section after anything you have,
Add
Script
Shutdown

The leadout is played at the end of your scheduled playlist. So if you have playlist1 scheduled from 5p.m.-10p.m., at 10 pm, it will play your lead out sequences and then run the shutdown script.

Your FPP controlled device should start on power up and immediately begin running what ever you have scheduled (or nothing if you have nothing scheduled).

I knew I had tried that before, but there's no place to search when I go to the script repository browser, see screenshot. What am I missing?

I did find the shutdown.sh on github and think I can download then upload it to FPP but the repository browser would be easier.

Screen Shot 2021 09 20 at 8.57.55 PM

Reply
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago

So I just read a note in the FPP manual that DNS settings need to be configured in order to see the repository. I'm going to enable that on my router and check back with the FPP tomorrow.


Reply
Posts: 242
Topic starter
(@rsegreto)
Reputable Member
Joined: 6 years ago

Just doubling back, I was able to get my DNS settings right and download the shutdown script from the repository so all is working!
Thanks again,
-Russ


Reply
Share: