FPP Channel testing
 
Notifications
Clear all

FPP Channel testing

16 Posts
3 Users
0 Reactions
7,312 Views
Posts: 242
Topic starter
(@hockeyhunter1956)
Reputable Member
Joined: 13 years ago
mrGrumpy wrote:Going back is too hard and likely will not change anything. Try to redo the update

I tried the update again. No success.

Utimgr wrote:So you know when you post a question and then you solve it? Found my issue. In FPP channel output, I had type set to multicast, and have a unicast address set for the F4V3. Which makes sense, in that right now I only have the F4V3 as a pixel driver.

Sorry for the question, but maybe it will help someone else later on.

Not sure if this is something that will work for me or not. I'm still considering reformatting the SD card again and installing FPP v4.3. I can't think on anything else to try at this point.

But thanks for all the suggestions.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I think you need to look outside of FPP for issues. Look at channel inputs to controllers. I don’t feel FPP is the issue.


Reply
Posts: 242
Topic starter
(@hockeyhunter1956)
Reputable Member
Joined: 13 years ago

You might be right. I may have made some assumptions (hate that word) based off the fact that I was able to access the Falcon controllers through the the FPP. Should I look at the E131/Artnet setup on the Falcon Controllers?


Reply
Posts: 242
Topic starter
(@hockeyhunter1956)
Reputable Member
Joined: 13 years ago

So I think the problem might be solved. I was able to get one controller to work using the FPP Channel Testing page this morning. The E131/Artnet Universes were not set up correctly in the first Falcon controller I just checked. So you were right that this was not a FPP problem but a controller configuration problem.

I'm always a little surprised by how much I get "schooled by networking issues. It's the least favorite part of this hobby for me. I would so much rather build/weld and wire props than figure out these types of problems. Good thing my wife does all the sequencing or I would be tipped over by now.

Thanks for all the help!


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

I hear you enjoying your success. Congrats, and so happy you didn't give-up


Reply
Posts: 451
(@utimgr)
Honorable Member
Joined: 14 years ago

I'd update Xlights....but it won't. Yep, disabled the virus (uninstalled them actually) checkers, but I get the blue circle of patience for a moment and then nothing. I'm afraid to uninstall what I have in case it won't install again.


Reply
Page 2 / 2
Share: