I finally decided to jump from using Vixen to run my show and use a Raspberry 3B+ with FPP v 4.3.1. I’m sure once I get the hang of a few things it will be a better set up. I’m having a few challenges and finally decided to ask for help.
I currently accessing FPP wirelessly from my computer and have the Raspberry Pi -network switch – Falcon controllers working. I have my FPP Channel outputs set up. I’m able to access the various Falcon controllers. run test patterns, and check out the strings of lights I currently have already installed. The first challenge that I can’t figure out is why I’ve not been able to get the FPP Channel testing to test the lights also. Am I missing something in my FPP configuration?
Thank for the help.
Have you setup and enabled your ""Input/Output Setup" ?
"Enable E1.31 / ArtNet / DDP Output:"
screen to output E1.31 to pixels.
Yes, that look good. With output configured, all I need to do is go to test screen, set the start test channel and end test channel, then enable test. If you have test start/end correct and enable test doesn’t light pixel, look outside of FPP
Did you ping your controllers on the output screen?
That looks good to. One more thing to try. Try changing from eth0 to wlan0 on output screen - will need to restart fppd
Tried that as well. No success. I'm guessing that my update must have corrupted FPP some how. I'll try going back to FPP 4.3 in the morning and see if that does anything.
Interesting in that I am having a nearly identical problem, running V3.6.2
It has worked in the past, its how I was testing the pixels as I was building the system. The F4V3 can ping the FPP just fine, and I can drive a sequence from Xlights thru the F4V3, I can run the test sequence from the F4V3, its simply now for some reason the FPP won't drive anything to the F4V3
I have the channel outputs enabled, tried eth0 and WLAN.
I've made a single universe as well, 170 pixels/510 channels. Thats whats in everything. Head scratcher....
Going back is too hard and likely will not change anything. Try to redo the update
So you know when you post a question and then you solve it? Found my issue. In FPP channel output, I had type set to multicast, and have a unicast address set for the F4V3. Which makes sense, in that right now I only have the F4V3 as a pixel driver.
Sorry for the question, but maybe it will help someone else later on.


