DMX Outdoor cable
 
Notifications
Clear all

DMX Outdoor cable

48 Posts
19 Users
0 Reactions
17.7 K Views
Posts: 91
Topic starter
(@franchise)
Estimable Member
Joined: 19 years ago
[#31813]

I have been running a small, 20 channel display for around 8 years now where I have all the dimmer boxes in the garage and I run power extension cords outside. I want to add some RGB flood lights this year. I found some RGB Floods from Ray Wu that look like they will work. Dumb question, what do I do about outdoor DMX cables? Google searches seem to find cables that convert from indoor to outdoor DMX (which I don't understand.)


47 Replies
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago
Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

Cat5 or Cat6 will both work but the alarm cable is not your best bet. It has all kinds of technical issues that you may or may not run into problems with. There is also real DMX low capacitance 120 ohm impedance cable made for RS485. You might get luck and the alarm stuff will work for you.. but then again.. you might not.. Go with what is correct for the application..

Just my two cents worth..


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

I'd be interested in hearing why...as there is no difference between 18/4 alarm wire and 22/8 cat 6 other than 4 extra strands and size. Youll even need to double or triple wire cat6 due to.its size. You will also have to deal with the brittleness of cat cable. I do use both myself. I have heard of issues with maybe SHIELDED alarm wire...


Reply
Posts: 46
(@rangerdan)
Trusted Member
Joined: 15 years ago

alarm cable is not twisted pair. Cat 6 twists the pairs to reduce noise on the signals, and your talking about low voltage low current so doubling the wires is not necessary. 485 for the DMX signal will go a long way down the cable because of the balanced interface.


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

You can buy CAT5E cable rated for outdoor use. Check with your local electrical supplier.


Reply
Posts: 91
(@davrus)
Estimable Member
Joined: 13 years ago

If you want to send the power for your Floodlight down the same CAT5 cable as your data, then you do need to double or triple up on the wires used for the power. Data will be OK on just one wire, but 12V +ve and -ve will not travel very far on a single wire.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Yeah, I have seen where people have doubled the data line and it caused issues. I know some use cat cable and some use speaker or alarm cable. I don't think I've read where people have had issues with either. Once the data gets on the pixels...its standard wire anyway our distance to the first pixel is a short distance as well.


Reply
DrNeutron
Posts: 2018
(@drneutron)
Noble Member
Joined: 14 years ago

Actually I buy all my cables from a US distributor on ebay called Cable-Zilla. Buying cable (as with most stuff) is super expensive in Canada so it is cheaper to buy US and pay the shipping.
I usually get 500ft of 4 conductor 18ga Security cable for $60.00 plus $10.00 shipping to Nova Scotia, that is pretty good.
A quick look and you can get 1000' of outdoor rated direct burial Cat5e for about $80.00
Check them out: http://stores.ebay.ca/cable-zilla?_trksid=p2047675.l2563


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

There are lots and lots of articles about RS485 and cables.. The bottom line here is that this is a hobby where trial and error seems to be common place... as with many hobbies. But what works for one does not always work for the next person that tries it for one reason or another..

If however you follow good standard practices you stand a much better chance of success as opposed to the hit and miss approach. Alarm cable may work for some since RS485 is a pretty robust protocol, but you may run into troubles simply by the cables you use.. Wanna waste time troubleshooting just because you have the wrong cable? Hey, it's a hobby.. have fun with it.. but myself, I would rather figure out how to build the next big thing rather than how to fix what shouldn't be broken..


Reply
Page 1 / 5
Share: