OK - I updated the power section a bit - rotating the 2575 definitely helped the layout. It's not quite as tight as it might be but I think it's pretty close.
That's not bad. Maybe rotate the 5v bypass connector and slide the output cap to the right a bit? Also, be careful of the connection between the trace from the inductor and the trace from the bypass connector; that very acute angle there forms an acid trap, and can cause the traces to get undercut there during eching. You can always run the bypass trace directly to the inductor pad it have it connect to the inductor trace at 90 degrees rather than 135. The more boards I do, the more I realize and understand why it is called "artwork"...
/mike
I'd change the silkscreen to show the complete LM2575 number since they come in tons of different packages. Are you specing the LM2575S? Fixed voltage or adjustable voltage?
budude wrote:OK - I updated the power section a bit - rotating the 2575 definitely helped the layout. It's not quite as tight as it might be but I think it's pretty close.
He is using the fixed regulator. To use the adjustable one, you would need to add two resistors to form a voltage divider for the feedback line. They could be placed between the oscillator and catch diode. It may make sense to add them anyway; for a fixed regulator, just load the top one with a 0-ohm resistor or wire jumper. That way, you can use whichever regulator is on hand.
/mike
Yep - using the 5v fixed version - keep in mind the BOM will be updated with the proper part numbers so hopefully it will be clear which one to get.
I am also looking at creating a module using SM parts as a drop-in replacement for the 7805. I realize these already exist but I'm a tad worried that they aren't available from the larger distribution places like Mouser, Digi-Key, etc. Of course that doesn't mean they will have parts available all the time either (in fact the SM version of the 2575 was OOS at Mouser and I had to go with Digi-Key) but if we get enough interest it might be cheaper than buying them separately - just have to work out the numbers.
I think this module would work for other applications like the Ren24LV as well.
