Super Strip Flood C...
 
Notifications
Clear all

Super Strip Flood Controller

240 Posts
30 Users
0 Reactions
91.6 K Views
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I'll take two!


Reply
dlovely
Posts: 3167
(@dlovely)
Famed Member
Joined: 17 years ago

budude, What would have to be added to give the option of DMX or Renard programed PICs?


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
dlovely wrote:budude, What would have to be added to give the option of DMX or Renard programed PICs?

The board will support Renard or Renard/DMX code and Renard mode will support RS-232 or RS-485. The PIC layout (including in/out) is lifted right from the RenSS schematic. I might add jumpers to jump out the PICs Rx/Tx (pins 5&6) so that you don't have to fully populate the board but still be able to daisy-chain the boards (i.e. make it a Ren8/16/24/32/40/48). It won't cost anything to add anyway.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

The PCB design in post#1 appears to be an ExpressPCB design...there shouldn't be any difficulty putting the outputs in the normal order. One way to do it is to copy Wayne's layout for the Renard-SS board or my design for the Ren64. It's a bit of work and will possibly involve running traces between the IC pads, but will make things easier for people using it later on.


Reply
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

Wonderful Design! The only thing I would be cautious of is voltage drop. Cat5 is not the best of conductors for current AFAIK. Even a 50ft run with 360mA is a drop of roughly 7.5%. (somebody want to confirm that?)

YMMV


Reply
Page 2 / 48
Share: