I want to convert my entire setup to DMX this year. Last year I had a mix of DMX for my LOR and FreeStyle and used four Renard 16 Simple controllers to drive my DCSSRs to my Super Strip Floods. I'm laying out a board to drive 12 strips so that I will only need two of them to drive my 24 strips (well - I actually have 25 but guess it's good to have a spare). I'm also laying out another DC controller using ULN2803 drivers but it's not the best option to drive the strips IMO. I haven't picked out the driver yet but probably something like a 2n2222 transistor as others are using for similar projects. It will use RJ45 jacks with the appropriate pinouts to run the strips directly.
I want to be sure to support a full strip on so worst case would be 360ma on four separate channels. Yes - - I know it's unlikely that I would sequence with RGB+W all on 100% - but I also don't want to go "uhh - oops"... :rolleyes:
edit - Final version out to fab...
Great idea!
Any idea on the cost to populate the pcb?
DIY Guy wrote:Great idea!Any idea on the cost to populate the pcb?
Probably under $50 - but that's a quick SWAG...
edit - - one minor detail - as the RenDMX (or standard Ren) code stands today the layout would drive the pins on the strips in the reverse order - - that is, it would go WBGR and not RGBW. This was done to keep the layout to the RJ45s simple. Not a big deal but I am looking at changing the code to put them in the "normal" order...
bought time, that is what i have been looking for my archs too, lol. ill be watching this thread. would def be cheaper than running 2 ren24lv per arch lol.
Sweet! Exactly what I am looking for, I am looking to power 12 strips myself.
Dave
