Stepper Motor contr...
 
Notifications
Clear all

Stepper Motor control

17 Posts
11 Users
0 Reactions
7,694 Views
Posts: 283
(@eswets)
Reputable Member
Joined: 18 years ago

If the servo works for your design, Matt's link will work fine. You just have to find the resistor values for the degree setting for 0 then add a switch and second resistor in parallel to the circuit. So if R2 needs to be 100ohms (just throwing out values) for 0deg, and 90deg needs to be 50ohms, you need 2 100ohms resistors in parallel but one needs to be switched.


Reply
Posts: 859
(@smartalec)
Prominent Member
Joined: 17 years ago

might sound silly, but what about your windscreen wiper motor from a car?

Wayne J wrote:Hey guys, I got a little personal project going and thinking a stepper motor will work out well. Problem is, I can't find the circuit I am looking for to control it.
What I want to do is.... the motor to start at 0 degrees, then I want to flip a switch and it rotate to 90 degrees and holds. Flip the switch back, and it returns to 0 degrees.

If I can find one that works, I would rather use a linear motor and control it the same way.

Can you guys help?


Reply
Posts: 502
(@mmulvenna)
Honorable Member
Joined: 19 years ago

Although I have not built it yet, I purchased Franks servo controller. His website indicates it will also drive a stepper motor with a slight modification.


Reply
Posts: 597
(@entropy)
Honorable Member
Joined: 19 years ago

Wayne, how are your microcontroller skills?

This would be something pretty easy to do with a PIC or AVR, even using one of the "abstraction layer" development environments (Basic Stamp for PIC, Arduino dev environment for AVR.)


Reply
Posts: 136
(@j1sys)
Estimable Member
Joined: 17 years ago

Entropy - good idea.

let's take it one step further.

What about taking a low voltage version of something like an SS8, replacing Renard code with 'Renard-Stepper' code (needs to be written) that would consume 8 slots like a usual Renard and then use one or two of the slots to drive one or two stepper motors hooked up to the outputs. Need to work out a lot of details, but couldn't a 'Renard-Stepper' be used for many projects.

-Ed


Reply
Page 2 / 4
Share: