Stepper Motor contr...
 
Notifications
Clear all

Stepper Motor control

17 Posts
11 Users
0 Reactions
7,693 Views
Wayne J
Posts: 7789
Topic starter
(@wayne-j)
Illustrious Member
Joined: 19 years ago
[#11127]

Hey guys, I got a little personal project going and thinking a stepper motor will work out well. Problem is, I can't find the circuit I am looking for to control it.
What I want to do is.... the motor to start at 0 degrees, then I want to flip a switch and it rotate to 90 degrees and holds. Flip the switch back, and it returns to 0 degrees.

If I can find one that works, I would rather use a linear motor and control it the same way.

Can you guys help?


16 Replies
dnesci
Posts: 563
(@dnesci)
Honorable Member
Joined: 19 years ago

Wayne,

How much power does the motor need? There are several model railroading stall motor out there that can be set to stall at 90 degrees and then revered with a double pole double throw switch to go back and stall at 0 degrees. Most need resiters for model RR use as they are powerful enough to bend the track at full voltage. They can be run at 6-12 volts DC.

Other wise here is a stepper motor control circuit http://home.cogeco.ca/~rpaisley4/Bipolar.html

Don


Reply
Wayne J
Posts: 7789
Topic starter
(@wayne-j)
Illustrious Member
Joined: 19 years ago
dnesci wrote:Wayne,

How much power does the motor need? There are several model railroading stall motor out there that can be set to stall at 90 degrees and then revered with a double pole double throw switch to go back and stall at 0 degrees. Most need resiters for model RR use as they are powerful enough to bend the track at full voltage. They can be run at 6-12 volts DC.

Don

Sounds interesting and may work, have any links?


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

Wayne,
your ap sound more suited to a servo motor.
Have a look at this example
In your case you would replace P1 with two resistor as a switch.


Reply
Wayne J
Posts: 7789
Topic starter
(@wayne-j)
Illustrious Member
Joined: 19 years ago
Matt_Edwards wrote:Wayne,
your ap sound more suited to a servo motor.
Have a look at this example
In your case you would replace P1 with two resistor as a switch.

That was my first idea, but it would need the use of two pots wired to the switch to achieve the results I need.


Reply
Page 1 / 4
Share: