Ok thanks Mac planning on 57.6K at least for now but my channel count is creeping up and will have to change to 115.2K in a season or two.
smartalec wrote:Any update with the DMX ?
thanks
Hi Alec,
Nothing yet on DMX,,, I just moved from one side of the country to the other and I am in the process of getting settled in after 3,042 miles... Hopefully I will be getting some of the DMX Gurus involved with DMX for the Simples Renard's soon since I am clueless when it comes to DMX....there are a bunch of DMX folks here at DIYC so hopefully some will chime in and volunteer their expertise/services or Paint a Fence (Tom Sawyer Project).:biggrin2:
I just wanted to thank you two for making a great board.
The BOM, assembly, and wiki instructions are all great. I was able build 2 of these last night and I went from "soldering iron on" to "power tested" in a little over an hour total. Not bad for 64 channels!
I'm hoping tonight I can get the pickit out and do more testing than the multimeter power tests.
Materdaddy wrote:I just wanted to thank you two for making a great board.The BOM, assembly, and wiki instructions are all great. I was able build 2 of these last night and I went from "soldering iron on" to "power tested" in a little over an hour total. Not bad for 64 channels!
I'm hoping tonight I can get the pickit out and do more testing than the multimeter power tests.
Hi M Daddy,
Good to hear you got them ready to go,,, if you have any issues with the boards let us know..
BTW... Jack (jklingert) put the info in the Wiki and he did a great job....
Thanks again.
Mac
Mactayl wrote:Hi M Daddy,Good to hear you got them ready to go,,, if you have any issues with the boards let us know..
BTW... Jack (jklingert) put the info in the Wiki and he did a great job....Thanks again.
Mac
A couple things I noticed when getting the firmware going:
1. The wiki page says the default is 57.6k baud, but the ".inc" file has 115.2k on the code linked in the file library.
2. The file linked in the library contains itself. When you extract the zip, you get a directory with a zip and another directory inside it. The zip is simply the second level directory.
3. Maybe mention that you should not have power applied to the board. When programming, the pickit device will power the chip for programming. I was getting Vpp errors until I removed power. I'm used to using my mkII on an arduino board which requires both the arduino board to be powered and the programmer, so this might be different for me. All the other PICs I've programmed were off-board using a simple BOB. Luckily applying power doesn't screw anything up, it simply gives an error when attempting programming.
