Simple Renard 32
 
Notifications
Clear all

Simple Renard 32

103 Posts
25 Users
0 Reactions
56 K Views
Posts: 393
(@soakes94)
Honorable Member
Joined: 18 years ago

If I used the same resistors as the ones used in the ren-c to grinch convertor with 24vac would that work? As I've got loads of them hahah

Steve


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
soakes94 wrote:If I used the same resistors as the ones used in the ren-c to grinch convertor with 24vac would that work? As I've got loads of them hahah

Steve

what value resistor are you using? make sure your cap on the input of the VReg is rated at least 50VDC, you will be dissipating a lot more heat through the voltage regulator using a 24VAC transformer and you will need a heat sink on it.

edit,,, BTW are going to use DC SSR's or AC SSR's, if you are going to use DC SSR's you will not need the H11AA1 and the two ZC resistors, they are only needed for AC SSR's.


Reply
Posts: 8
(@relewis)
Active Member
Joined: 15 years ago

hi all - I was developing a Picaxe based demux running on the generic serial protocol, but realised after rushing it for this Christmas that I was actually just re-designing something that already existed. Where can i get the firmware and details for the Renard 32?
Cheers
Rob


Reply
RavingLunatic
Posts: 1502
(@ravinglunatic)
Noble Member
Joined: 19 years ago

Start at the beginning of this thread. By the time you get to post 17 all should be clear. 😉


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
relewis wrote:hi all - I was developing a Picaxe based demux running on the generic serial protocol, but realised after rushing it for this Christmas that I was actually just re-designing something that already existed. Where can i get the firmware and details for the Renard 32?
Cheers
Rob

Here is the info on the SR 32. The reason you will not find any info in the Wiki is due to the DIYC site crash back in November, I was almost finished entering all the info in the Wiki and the site went down for a week,, when it came back up the info I entered was all gone.. As you probably already know the site is not back up 100%. After It is back up and fully functional I will re-enter all the data again. For now I included a few files. Hope this helps. Here is the link to the PCB's if you are interested in them. http://n7xg.net/diycprojects.html


Reply
Page 13 / 21
Share: