Renard based Servo ...
 
Notifications
Clear all

Renard based Servo controller

51 Posts
16 Users
0 Reactions
33.5 K Views
Posts: 919
(@scorpia)
Noble Member
Joined: 19 years ago
ctmal wrote:Thanks, I'll put all everything up once I clean it up.

just for an FYI,

If you can make the board under 5cmx5cm (2inx2in) then seeedstudio pcb service is a cheap way of getting a small run of boards made up for testing.

Peter


Reply
Posts: 899
 lbro
(@lbro)
Noble Member
Joined: 19 years ago

How are you planning on using th board? Do you have something you needed it for?


Reply
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
lbro wrote:How are you planning on using th board? Do you have something you needed it for?

My neighbor has challenged me saying she could out decorate me for Halloween. As long as I have time I'm planning on making either a talking skeleton or some kind of talking monster.


Reply
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

I was able to get some testing done. The results were great. I had the Servo controller connect to the computer then an XMUS Ren 16 connected in line. All worked as you would expect. The +12 volts and Ground were passed to the XMUS board with no issue.

I also cleaned up the code a bit and made the pads on all the resistors a bit larger to make it easier to solder. I'll have to etch another board to be sure but those changes shouldn't effect anything.

I'm going to post everything(in a couple of additional posts) if anybody is interest in playing/testing.

As always, and comments, suggestions or criticisms are welcome.

Chris


Reply
Posts: 2215
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

Attached is the code and the BOM I used. You see that almost all of the parts are the same numbers as the Renard SS series Boards.

A note about the bom. For the header for the Servos I just used header I removed from an old motherboard. I was looking on Mouser and I think 538-10-89-7061 would fit the bill but I'm not totally sure so if anyone can chime in on that it would be appreciated.

Basically what I've done is take the origional Renard code and modified it for use as a servo. I did not write the Rx routines, etc. myself, that was all from the origional Renard code.


Reply
Page 2 / 11
Share: