Renard based Servo ...
 
Notifications
Clear all

Renard based Servo controller

51 Posts
16 Users
0 Reactions
33.5 K Views
Posts: 2216
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

Here's the board. Note there are two jumper wires on there. I wasn't really sure how I wanted to notate them on the silkscreen so I didn't do it;)

The DC input is 5V and the board will pass on the Zero cross signal if it's on port 3 and also the +12DC and Ground if present as in the xmus board setups.

Any question, give a shout.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
ctmal wrote:Here's the board. Note there are two jumper wires on there. I wasn't really sure how I wanted to notate them on the silkscreen so I didn't do it;)

The DC input is 5V and the board will pass on the Zero cross signal if it's on port 3 and also the +12DC and Ground if present as in the xmus board setups.

Any question, give a shout.

Does the PIC source/sink enough current to drive the servos? I don't know much about servos but was wondering if a driver (ULN2803, transistor, etc) is required? I think the PIC can sink 90mA max for all outputs (something like 15mA per single output with derating?).


Reply
Posts: 2216
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago

I wasn't able to find any documentation but I measured the current in the signal wire to the servo. The highest I came up with way .036 ma so it shouldn't be a problem.


Reply
Posts: 999
(@ppohlman)
Noble Member
Joined: 19 years ago

hey ctmal -

This is great!! Thanks for putting this together.
omzig had started something similar in this thread, but he got busy and had to postpone his project. I will definitely be looking at doing some 3-axis skulls as well.


Reply
Posts: 2216
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
Reply
Page 3 / 11
Share: