Is it possible that this would interface with a "linistepper". I am in the process of biulding this servo/stepper Driver for 1amp motors and it would be nice to control with Vixen .
The control signal for hobby servos is just that - a control signal. The current requirement is quite low, and I'm quite surprised that it is as high as the 36mA that ctmal measured.
P. Short wrote:The control signal for hobby servos is just that - a control signal. The current requirement is quite low, and I'm quite surprised that it is as high as the 36mA that ctmal measured.
It was .036ma that I read. Not totally sure of the accuracy since the batteries in my multimeter need to be replaced but well within the limits of the pic.
Is it possible that this would interface with a "linistepper". I am in the process of biulding this servo/stepper Driver for 1amp motors and it would be nice to control with Vixen .
I'm not familiar with the "linistepper" so I can't really comment on it. This board just supplies the +5v, Ground and signal to control the servos.
I'm not familiar with the "linistepper" so I can't really comment on it. This board just supplies the +5v, Ground and signal to control the servos.
"www.romanblack.com" version 2 of his linistepper for test purposes they are using 555s. If you are able to purouse this unit and give me an opinion would be much appreciated. John.
jmksparks wrote:I'm not familiar with the "linistepper" so I can't really comment on it. This board just supplies the +5v, Ground and signal to control the servos.
"www.romanblack.com" version 2 of his linistepper for test purposes they are using 555s. If you are able to purouse this unit and give me an opinion would be much appreciated. John.
Again, I'm not really familiar with it but it doesn't look to me like would work. That board appears to accept CNC protocol input from a computer, not server signals.
